倍加福P+F EL2889

The EL2889 digital output terminal connects the binary 24 V DC control signals from the automation device on to the actuators at the process level with electrical isolation. The EtherCAT Terminal has 16 channels, whose signal states are indicated by LEDs. The connection technology is particularly suitable for single-ended inputs. All components have to use the same reference point as the EL2889. The power contacts are connected through. In the EL2889 the outputs are supplied via the 0 V DC power contact.

Special features:

ground switching

Connection of different load types possible (ohmic, inductive, lamp load)

Max. output current 0.5 A per channel

Overload and short-circuit proof outputs and reverse polarity protection

Tool-free connection by direct plug-in technology for solid wire conductors

Space-saving use in the control cabinet

Direct connection of multi-channel sensors in 1-wire connection technology in the smallest space

Increased packing density with 16 connection points in the housing of a 12 mm terminal block

EL2889数字输出端子将来自自动化设备的二进制24 V DC控制信号连接到工艺级执行器，并进行电气隔离。EtherCAT终端有16个信道，其信号状态由LED指示。连接技术特别适用于单端输入。所有部件必须使用与EL2889相同的参考点。电源触点通过连接。在EL2889中，输出通过0 V DC电源触点提供。

特殊功能：

接地开关

可能连接不同负载类型（欧姆、电感、灯负载）

每个通道最大输出电流0.5 A

过载和短路保护输出和反极性保护

实心导线直接插入技术的无工具连接

控制柜节省空间

在最小空间内采用单线连接技术直接连接多通道传感器

增加了12 mm接线盒外壳中16个连接点的包装密度

倍加福P+F EL2889 文章出自长欣工控转载请附上链接